As was mentioned in Section 6.4, if a generators reactive
Chapter , Problem 6.47(choose chapter or problem)
As was mentioned in Section 6.4, if a generators reactive power output reaches its limit, then it is modeled as though it were a PQ bus. Repeat 6.46, except assume the generator at bus 2 is operating with its reactive power limited to a maximum of 50 Mvar. Then verify your solution by solving the case with PowerWorld Simulator. To increase the reactive power output of the bus 2 generator, select Tools, Play to begin the power flow simulation, then click on the up arrow on the bus 2 magenta voltage setpoint field until the reactive power output reaches its maximum.
Unfortunately, we don't have that question answered yet. But you can get it answered in just 5 hours by Logging in or Becoming a subscriber.
Becoming a subscriber
Or look for another answer