Replace the three forces acting on the shaft by a single resultant force. Specify where the force acts., measured from end A.
“Circuit Analysis: Series and Parallel” Presented to The Faculty of the College of ECST California State University, Los Angeles In Partial Fulfillment of the Requirements for ENGR 1500 By Mechanators and Hector Linares, Marcos Maravilla, Leo Sanchez, Giovanny Sanchez and Luis Cortez September 2016 Introduction. The lab that took place on Friday, September 30 2016, identified both parallel and series circuits. The lab also consisted of verifying the resistance in a resistor. Each individual group participating in the lab got the materials and tools needed to analyze a simple circuit with two different resistors. The objective of this lab was to give an understanding on how to apply the numbers given by the resistance formula to a real life situation, how each type of circuit compares to one another, understand the settings of the multimeter and to get hands on experience with the material that build up the circuits. This lab is important because it gives us hand on experience of what we are learning in our lecture class. We also learned how to understand the numbers the multimeter provides and what each
