A punch-press geared 10:1 is to make six punches per

Chapter 16, Problem 16.29

(choose chapter or problem)

A punch-press geared 10:1 is to make six punches per minute under circumstances where the torque on the crankshaft is 1300 lbf ? ft for 1 2 s. The motors nameplate reads 3 bhp at 1125 rev/min for continuous duty. Design a satisfactory flywheel for use on the motor shaft to the extent of IP IP IM TM IG1 IG2 IL n m R = nm bud98209_ch16_817-870.indd Page 869 22/11/13 3:02 PM user-f-w-198 /204/MH01996/bud98209_disk1of1/0073398209/bud98209_pagefiles 870 Mechanical Engineering Design specifying material and rim inside and outside diameters as well as its width. As you prepare your specifications, note vmax, vmin, the coefficient of speed fluctuation Cs, energy transfer, and peak power that the flywheel transmits to the punch-press. Note power and shock conditions imposed on the gear train because the flywheel is on the motor shaft.

Unfortunately, we don't have that question answered yet. But you can get it answered in just 5 hours by Logging in or Becoming a subscriber.

Becoming a subscriber
Or look for another answer

×

Login

Login or Sign up for access to all of our study tools and educational content!

Forgot password?
Register Now

×

Register

Sign up for access to all content on our site!

Or login if you already have an account

×

Reset password

If you have an active account we’ll send you an e-mail for password recovery

Or login if you have your password back