Member ABC, which is supported by a pin and bracket at C and Review 47a cable BD, was designed to support the 16-kN load P as shown.Knowing that the ultimate load for cable BD is 100 kN, determinethe factor of safety with respect to cable failure.
Ohm’s Law Evan Deller and Charlie Rivera th January 27 , 2017 Abstract To illustrate the properties that make up Ohm’s law, an experiment was setup in order to measure the relationship between voltage, current and resistance. This was done using a series circuit combined with various resistors, a circuit, and power source. Two multi-meters were used to measure current and voltage, while resistance was given by 10 and 50 ohm resistors. Values of current and voltage were recorded for each resistor. This data served to illustrate the basis of Ohm’s law. Plugging the found data points into Ohm’s law ensured that the experiment
