How many poles are in the right half-plane, in the left half-plane, and on the j-axis for the open-loop system of Figure P6.1? [Section: 6.3]
COMPUTERARCHITECTURE FALLSEMESTER2016 INSTRUCTOR:DR.KARENMAZIDI kmazidi@utdallas.edu 16 September 2016 These sets of notes will be covering the subjects covered in CS 3340.003 (and other). This packet will cover topics within Chapter 2 of Computer Organization and Design, Fifth Edition: The Hardware/Software Interface by Patterson and Hennessay. Any material on these pages include but are not limited to presentational slides provided by the professor. Each set may contain concluding remarks at the end of each set. Calling Procedures In order to call a procedure there are multiple steps that need to be taken. 1. Place parameters in registers 2. Transfer control to procedure 3. Acquire storage for procedure 4. Perform procedure’s operations 5. Place result
