You are trying to understand how a reciprocating air compressor (a piston-cylinder device) works. What system would you use? What type of system is this?
6/09/2017 Model 1: 1. Uncheck Auto-dimensioning before anything else 2. Draw a rough hexagon making the base parallel to the x-axis 3. Use rapid dimension to make the base of the hexagon and change it to 35mm 4. After that find the geometric constrains tool set and use the “equal length” tool and select all the sides of the hexagon except the base and then select the base of the hexagon that should be 35mm. 5. Using the “angular dimension” tool set any of the angle of the hexagon to be 120°, since you have the equal length constraint all the angles should change to 120°. 6. Finally draw a line from the right point of the base of the hexagon that is 50mm. You should end