For the pressure vessel defined in the problem
Chapter 8, Problem 8-41(choose chapter or problem)
For the pressure vessel defined in the problem specified in the table, redesign the bolt specifications to satisfy all of the following requirements.
• Use coarse-thread bolts selecting a class from Table 8–11 for Probs. 8–41 and 8–43, or a grade from Table 8–9 for Probs. 8–42 and 8–44.
• To ensure adequate gasket sealing around the bolt circle, use enough bolts to provide a maximum center-to-center distance between bolts of four bolt diameters.
• Obtain a joint stiffness constant C between 0.2 and 0.3 to ensure most of the pressure load is carried by the members.
• The bolts may be reused, so the yielding factor of safety should be at least 1.1.
• The overload factor and the joint separation factor should allow for the pressure to exceed the expected pressure by 15 percent.
Problem Number |
Originating Problem Number |
8-41 |
8-33 |
Unfortunately, we don't have that question answered yet. But you can get it answered in just 5 hours by Logging in or Becoming a subscriber.
Becoming a subscriber
Or look for another answer