- 10.10.4: Given the open-delta VT connection shown in Figure 10.38, both VTs ...
- 10.10.5: A CT with an excitation curve given in Figure 10.39 has a rated cur...
- 10.10.6: The CT of 10.5 is utilized in conjunction with a current-sensitive ...
- 10.10.7: The input current to a CO-8 relay is 10 A. Determine the relay oper...
- 10.10.8: The relay in 10.2 has a time-dial setting of 4. Determine the relay...
- 10.10.9: An RC circuit used to produce time delay is shown in Figure 10.40. ...
- 10.10.1: Reconsider case (b) of 10.5. Let the load impedance 4:9 _ j0:5 W be...
- 10.10.11: Evaluate relay coordination for the minimum fault currents in Examp...
- 10.10.12: Repeat Example 10.4 for the following system data. Coordinate the r...
- 10.10.13: Using the current tap settings and time dial settings that you have...
- 10.10.14: An 11-kV radial system is shown in Figure 10.42. Assuming a CO-7 re...
- 10.10.15: Rework Example 10.5 for the following faults: (a) a three-phase, pe...
- 10.10.16: A three-phase 34.5-kV feeder supplying a 4-MVA load is protected by...
- 10.10.17: For the system shown in Figure 10.44, directional overcurrent relay...
- 10.10.18: (a) Draw the protective zones for the power system shown in Figure ...
- 10.10.19: Figure 10.46 shows three typical bus arrangements. Although the num...
- 10.10.2: Three-zone mho relays are used for transmission line protection of ...
- 10.10.21: Line impedances for the power system shown in Figure 10.47 are Z12 ...
- 10.10.22: Consider the transmission line shown in Figure 10.48 with series im...
- 10.10.23: A simple system with circuit breaker-relay locations is shown in Fi...
- 10.10.24: Select k such that the di_erential relay characteristic shown in Fi...
- 10.10.25: Consider a protected bus that terminates four lines, as shown in Fi...
- 10.10.26: A single-phase, 5-MVA, 20/8.66-kV transformer is protected by a di_...
- 10.10.27: A three-phase, 500-MVA, 345 kV D/500 kV Y transformer is protected ...
- 10.10.28: For a DY connected, 15-MVA, 33: 11 kV transformer with di_erential ...
- 10.10.29: Consider a three-phase DY connected, 30-MVA, 33: 11 kV transformer ...
- 10.10.3: Determine the CT ratios for di_erential protection of a three-phase...
- 10.9.65: Repeat 9.64, except place the fault at the TIM69 bus
Solutions for Chapter 10: Power System Analysis and Design 5th Edition
Full solutions for Power System Analysis and Design | 5th Edition
ISBN: 9781133172871
Chapter 10 includes 28 full step-by-step solutions. Since 28 problems in chapter 10 have been answered, more than 9657 students have viewed full step-by-step solutions from this chapter. This textbook survival guide was created for the textbook: Power System Analysis and Design, edition: 5. Power System Analysis and Design was written by and is associated to the ISBN: 9781133172871. This expansive textbook survival guide covers the following chapters and their solutions.