Augment the astable multivibrator circuit of Fig. 18.26(b) with an output limiter of the
Chapter 18, Problem 18.39(choose chapter or problem)
Augment the astable multivibrator circuit of Fig. 18.26(b) with an output limiter of the type shown in Fig. 18.25(b). Design the circuit to obtain an output square wave with 5-V amplitude and 1-kHz frequency using a 10-nF capacitor C. Use = 0.462, and design for a current in the resistive divider approximately equal to the average current in the RC network over a half-cycle. Assuming 13-V op-amp saturation voltages, arrange for the zener to operate at a minimum current of 1 mA. Specify the values of all resistors and the zenor voltage.
Unfortunately, we don't have that question answered yet. But you can get it answered in just 5 hours by Logging in or Becoming a subscriber.
Becoming a subscriber
Or look for another answer